User manual

ManualsBrandsElectrolux ManualsDomestic AppliancesFO950

ENGLISH

Something not working?

Problem Possible cause

• The machine does not start up:

• The door is not firmly closed.

• The machine is not plugged in or there is no power

at the socket.

• The main fuse or the fuse in the plug has blown.

• The “Start/Pause” button has not been depressed.

• The programme selector dial is not positioned

correctly.

• The machine does not fill:

• The water tap is closed.

• The inlet hose is squashed or kinked.

• The filter in the inlet hose is blocked.

• The machine fills then empties

immediately:

• The end of the drain hose is too low. Refer to

relevant paragraph in “water drainage” section.

• The machine does not empty

and/or does not spin:

• The drain hose is squashed or kinked.

• The drain pump is clogged.

• The laundry is not evenly distributed in the drum.

• There is water on the floor:

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• The cap on the emergency emptying hose has not

been replaced after cleaning the filter.

• The pump has not been fully screwed in after

cleaning.

• Unsatisfactory washing results:

• Too little detergent or unsuitable detergent has

been used.

• Stubborn stains have not been treated prior to

washing.

• The correct programme/temperature was not

selected.

• Excessive laundry load.

• The machine vibrates or is

noisy:

• The transit bolts and packing have not been

removed.

• The support feet have not been adjusted.

Problems which you can resolve yourself.

During machine operation it is possible that one of the End light starts to flash:

4 flashes= the door has not been closed

2 flashes= the machine does not empty

1 flash= the machine does not fill.

Once the problem has been eliminated, press the “Start/Pause” button to restart the programme. If after all

checks, the problem persists, contact your local Service Centre.