Service manual

is properly installed and grounded in accordance

with all local codes and ordinances or in the

absence of local codes, with the National Electrical

Codes, ANSI/NFPA 70 (latest edition). If in doubt,

call a licensed electrician.

DO NOT cut off or alter

the grounding prong on the power supply cord. In

situations where a two-slot receptacle is present, it

is the owner’s responsibility to have a licensed

electrician replace it with a properly grounded

three prong grounding type receptacle.

WATER SUPPLY REQUIREMENTS

Hot and cold water faucets MUST be installed within

42 inches (107 cm) of your washer’s water inlet. The

faucets MUST be 3/4 inch (1.9 cm) garden hose type

so inlet hoses can be connected. Water pressure

MUST be between 30 and 120 pounds per square inch

(maximum unbalance pressure, hot vs. cold, 10 psi.)

Your water department can advise you of your water

pressure. The hot water temperature should be about

140 degrees F (60 degrees C).

DRAIN REQUIREMENTS

1. Drain capable of eliminating 17 gals (64.3 L) per

minute.

2. A standpipe diameter of 1-1/4 in. (3.18 cm)

minimum.

3. The standpipe height above the floor should be:

Minimum height: 24 in. (61 cm)

Maximum height: 96 in. (244 cm)

NOTE: Drain hose attached to the washer can reach a

58 in. (147 cm) high standpipe. For higher

standpipe use hose P/N 134049201, available

from an authorized parts distributor. If drain is

less than 24 in. (61 cm), install a siphon break

kit, available at your local hardware store.