Service manual

18
12. Replace the service panel and screws.
NOTE: If the washer is to be transported at a later
date, the shipping support hardware must
be reinstalled to prevent shipping damage.
Retain the hardware in the plastic bag
provided.
INSTALLATION
1. Run some water from the
hot and cold faucets to flush
the water lines and remove
particles that might clog up
the water valve screens.
2. Remove the inlet hoses and
rubber washers from the
plastic bag and install the
rubber washers in each end
of the inlet hoses.
3. Carefully connect the inlet hose (90° elbow end)
marked "HOT" to the outside "H" outlet of the water
valve. Tighten by hand, then tighten another 2/3
turn with pliers. Carefully connect the other inlet
hose (90° elbow end) to the inside "C" outlet of the
water valve. Tighten by hand, then tighten another
2/3 turn with pliers.
Do not crossthread or over-tighten these
connections.
4. Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another
2/3 turn with pliers. Turn the water on and check for
leaks.
NOTE: Use only new hoses.
5. Carefully move the washer to its final location.
NOTE: Do not use the dispenser drawer or door to
lift washer.
6. With the washer in its final position, place a level
on top of the washer (if an undercounter
installation, no rocking of the washer should exist).
Adjust the front leveling legs up or down to ensure
the washer is resting solid. Turn the lock nuts on
each leg up towards the base of the washer and
snug with a wrench.
NOTE: Keep the leg extension at a minimum to
prevent excessive vibration. The farther out
the legs are extended the more the washer
will vibrate.
If the floor is not level or is damaged, the rear leveling
legs may have to be extended. For undercounter
installations, rear leg adjustment is accessible
through the front service panel.
7. Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place in a
laundry tub or standpipe and secure with the cable
tie provided in the enclosure package.
NOTE: If the drain hose is placed in a standpipe
without forming a U shape, a siphoning
action could occur. There must be an air
gap around the drain hose. A snug hose
fit can also cause a siphoning action.
8. Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power is off at a
circuit breaker/fuse box before plugging
the power cord into an outlet.
9. Turn on the power at a circuit breaker/fuse box.
10. Read the Operating Instructions and Owner’s
Guide provided with the washer. They contain
valuable and helpful information that will save you
time and money.
Cable Tie
Cable
Tie
Cable
Tie