Service manual

20
SECTION B - OPERATING
INSTRUCTIONS
Before Operating Your Washer
Read your washer Use and Care Guide. It has important
safety and warranty information. It also has many sug-
gestions for best washing results.
To reduce the risk of fire, electric shock
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your washer Use and Care Guide
before operating this appliance.
Operating Steps
Read and follow “Washing Procedures” in your Use and
Care Guide. It provides detailed information for preparing
the wash load and choosing control settings to ensure
best washing results.
1. Sort laundry into loads that can be washed together.
2. Prepare items for washing.
3. Pretreat stains and heavy soil.
4. Add laundry load to the wash drum.
5. Open the dispenser drawer and add the measured
amount of a high efficiency detergent to the
detergent compartment. If desired, add liquid bleach
and fabric softener to the appropriate compartments.
They will be dispensed at the proper times. Slowly
close dispenser drawer. The washer will not operate
with the drawer open.
Note: From time to time you may see water in the
bleach and fabric softener compartments. This is
a result of the siphoning action and is part of the
normal operation of the washer.
6. Press CYCLES until the desired cycle is selected.
Suitable wash and rinse water temperatures, final
spin speed and options will automatically be
displayed. To change these settings, press TEMPS,
SPEED and OPTIONS until the desired selections
are made. These adjustments to the cycle will
automatically be remembered each time that cycle
is selected.
7. To select or delete Heavy Soil/Stain, Auto Temp,
Extra Spin and Extra Rinse, press OPTIONS until
the flashing light indicates a desired option. Then
press SELECT to add or delete the option.
Note: To provide the best care for your laundry
items, not every temperature, speed and option is
available with every cycle.
8. Add desired features by pressing symbols for
· Control Lock
· End-of-Cycle Signal
9. Start the washer.
· Close the door and touch START. The washer will
not operate with the door open. As a safety
measure, the door will automatically lock during the
entire wash cycle and “DOOR LOCK” will be
displayed.
· To pause the cycle, press STOP/CLEAR once.
“PAU” will flash alternately with the time remaining
display. The door can then be opened to add a
forgotten item. However, if the washer was paused
during final spin, it will take approximately 2-3
minutes for the door lock to release. Do not force the
door open.
· To restart the washer, press START . Tumbling will
be resumed where it was interrupted. If the washer
was interrupted during spin, the spin time will be
reset.
· To stop the washer, press STOP/CLEAR twice.
Two dash lines will be displayed. They will disappear
after a short time.
10.A signal will sound when the end-of-cycle signal
option is selected. Remove items when cycle ends.
Cycle Selection
Press CYCLE until desired cycle is selected. For best
results, follow the fabric care label instructions on items
to be washed.