Service manual

22
Auto Temp
The temperature of hot, warm and cold wash water can
be affected by the water heater setting and seasonally
low ground water temperatures in some geographic ar-
eas. Since detergents work best in wash water at a mini-
mum of 65° F, select AUTO TEMP to regulate the tem-
perature of hot wash a approximately 150° F warm wash
to approximately 90° F and cold wash to approximately
70° F. Rinse water temperatures are not regulated.
Extra Rinse
Use this option when additional rinsing is desired to re-
move excess dirt and detergent. It is recommended for
heavily soiled loads or if household members have sen-
sitive skin. Extra Rinse occurs before the liquid fabric
softener is dispensed.
Extra Spin
Use this option for several additional minutes of spin at
the selected spin speed. This will increase water extrac-
tion and decrease drying time.
Washer Features
Control Lock
To prevent accidental operation of the washer or alter-
ation of the cycle settings, press and hold the lock sym-
bol until you hear 3 beeps and “LOC” is displayed. To
cancel, press and hold the lock symbol until “LOC” is no
longer displayed.
Signal
A signal will sound at the end of the cycle. Repeatedly
press the signal symbol to select one of three volume
levels or turn off the signal. The selection will be pro-
grammed until you change it.
Display
The following will be displayed during the cycle:
· Estimated Remaining Cycle Time
· Door Lock
· Cycle Status ( WASH, RINSE, FINAL SPIN).
· Signal volume selected
· “LOC” will be displayed briefly when lock symbol is
pressed.
Error Codes
If the washer stops and the F01, F03, F04 or F05 error
code is flashing in the display, press STOP/CLEAR,
select a cycle and press START. If the error code ap-
pears again, please contact service for assistance.
F01 There may be an internal problem with the wash
system.
F02 There may be a water temperature problem. Be
sure hot and cold water hoses are properly
connected before calling service.
F03 Be sure the water is turned on before calling
service. There may be a problem with the pump
or pressure switch.
F04 The washer may have run too long or there may
be a problem with the motor control.
F05 There may be a problem with the keypad.