Service manual

34
OCCURRENCE POSSIBLE CAUSE / SOLUTION
• Washer is not resting firmly on floor. Move washer so it rests firmly
on floor. Adjust leveling legs. See INSTALLATION INSTRUCTIONS
for details.
• Shipping bolts and foam block have not been removed during
installation. See INSTALLATION INSTRUCTIONS for removing
shipping bolts and foam block.
• Wash load unevenly distributed in drum. Stop washer and rearrange
wash load.
• Electrical power cord may not be plugged in or connection may be
loose. Make sure plug fits tightly in wall outlet.
• House fuse blown, circuit breaker tripped, or a power outage has
occurred. Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If problem is a circuit overload, have it corrected by
a qualified electrician. If problem is a power outage, call local
electric company.
• Water supply faucets are not turned on. “F01” is displayed. Turn
on water supply faucets.
• Cycle selector is not in correct position. Move indicator clockwise
slightly. Pull out knob.
• Motor is overheated. Washer motor will stop if it becomes
overheated. It will automatically restart after a cool down period of
up to 30 minutes (if washer has not been manually turned off).
• Dispenser drawer is not completely closed. Close dispenser
drawer.
• Washer door is not completely closed. “dr” (door open) is displayed
Close door completely.
• Dispenser drawer is not completely closed. “d:do” (dispenser
door) is displayed. Close dispenser drawer.
• Load is too small. Add 1 or 2 similar items to help balance the load.
• Heavily soiled items. Wipe drum with a nonabrasive household
cleanser, then rinse. Shake or brush excess dirt and sand from
items before washing.
• This is a result of the siphoning action and is part of the normal
operation of the washer. Water may be removed by removing the
dispenser drawer into the empty drum or sink.
• Washer is overloaded. Do not overload washer. See Washing
Procedures.
• Load is too small. Add 1 or 2 similar items to help balance the load.
• Load is out of balance. Rearrange load to allow proper spinning.
• Drain hose is kinked. Straighten drain hose.
• Water supply is not adequate in area. “F01” is displayed. Check
another faucet in the house. Wait until water supply and pressure
increase.
• Water supply faucets are not completely open. “F01” is displayed.
Fully open hot and cold faucets.
• Water is being used elsewhere in the house. Water pressure must
be at least 30 psi (260 kPa). Avoid running water elsewhere while
washer is filling.
• Water inlet hoses are kinked. Straighten hoses.
Vibrating noise.
Washer does not start.
Washer won’t spin.
Residue left in tub.
Water collects in bleach and fabric
softner compartments.
Wash load too wet after spin.
Water does not enter washer or it
enters slowly.