Service manual

44
The front loading, tumble action clothes washer consists
of a perforated, cylindrical spin basket suspended
horizontally on its axis within a larger solid cylindrical tub.
This assembly is suspended by springs within a four
piece steel cabinet. A see through door and a flexible
bellows (seal) provides access for loading and unloading
clothes.
Front console models are shipped with a painted top
panel, but a galvanized panel is available if the washer is
to be installed undercounter.
Cabinet
The cabinet is made of heavy steel in a four piece design
with an enamel finish. The sides and front are riveted at
the front corners and base. The rear of the cabinet is
galvanized steel and is secured with screws.
Front Panel and Door Assembly
The front panel is riveted to the side panels for maximum
strength and structural rigidity.
Bellows
The bellows is a rubber sleeve that seals the suspended
outer tub to the stationary cabinet front at the tub opening.
Its purpose is to provide a water tight opening into the tub
that can be sealed by the cabinet door, yet allow
flexibility for the oscillation of the tub during the wash and
spin cycles.
Outer Tub Assembly
The outer tub assembly is supported by two suspension
springs and stabilized by two air shock assemblies.
Cement counter weights are mounted to the outer tub
front (top & bottom), and the rear top. These counter
weights prevent excessive oscillation of the entire
suspended assembly during an unbalanced spin cycle.
Spin Basket Assembly
The spin basket is constructed of stainless steel. The
circumference of the basket is perforated to allow water
to flow through it as it revolves. A heavy steel shaft is
pressed into the spin basket support which is then bolted
to the basket. The spin basket assembly is entirely
supported by two ball bearings pressed into the rear of
the outer tub.
A large drive pulley is mounted to the free end of the shaft
that extends through the rear of the outer tub.
There are three plastic vanes mounted to the spin basket
to aid in the washing action during the wash cycle. The
rotation of the spin basket provides both the washing
action during the wash cycle, and water extraction
during the spin cycle.
SECTION E - CONSTRUCTION
Spin Basket
Outer Tub Rear
Outer Tub Front
Bellows (Door Boot)
Retaining Spring