Service manual

50
Washer does not advance
through the cycles.
Note: Always check
wiring to the components.
Washer does not advances
through the cycle. The
display may show (F 04).
With the washer operating measure
the voltage between pin (7) of the
seven pin plug and pin (1) of the
eight pin plug of the control board.
Above
70 VAC.
Defective
speed control
board.
Below
70 VAC.
Defective
control board.
Washer does
not drain. The display
may show F 03.
Touch the Drain/Spin Pad
does the drain pump run?
120 VAC.
Defective or
restricted
drain pump.
Pump impeller
broken or drain
hose plug.
Washer does not drain.
Note: Always check wiring to
the components.
No.
Yes.
Measure the voltage drop across
the terminals of the drain pump.
0.
Defective control
board or wiring
between the
control and drain
pump.
Note: The control board is the board in the console.
Note: The control board is the board in the console. The speed control board is the board in the
right rear corner.