Service manual

53
Drive motor spins but
does not tumble.
Display may show
F 04.
Defective
control board.
Program and start the washer
in the Haevy Wash Cycle. Make sure
the Heavy Soil/Stain is not activated.
Measure the voltage drop between pin 6 of
the six pin plug & pins 1, 2, 6, 9, & 10 of
the ten pin plug of the speed
control board.
If between pin 6 (6 pin plug) to pins
2, 6, and 10 (10 pin plug) reads 120
VAC and between pin 5 (6 pin plug)
to pins 1 & 9 (10 pin plug) read less
than 50 VAC.
Defective speed
control board.
If any other readings besides
120 VAC between pin 6 (6 pin
plug) to pins 2, 6, and 10 (10 pin
plug) and less than 50 between
pin 5 (6 pin plug) to pins 1 & 9
(10 pin plug).
Drive motor spins but does not tumble.
Note: Always check wiring
to the components.
Drive motor tumbles
but does not spin.
Display may show
F 04.
Defective
control board.
Program and start the washer
in the Drain/Spin Cycle.Disconnect
the six & ten pin plugs from the speed
control board. Measure the voltage drop
between pin 6 of the six pin plug
& pins 1, 2 ,6, 9, & 10 of the
ten pin plug.
If between pin 6 (6 pin plug) to pins
1, 2, 6, 9 &10 (10 pin plug) reads
120 VAC.
Defective speed
control board.
If any other readings besides 120
VAC.
Drive motor tumbles but does not spin.
Note: Always check wiring
to the components.
Note: The control board is the board in the console. The speed control board is the board in the
right rear corner.
Note: The control board is the board in the console. The speed control board is the board in the
right rear corner.