Service manual

54
Drive motor tumbles very
slowly when the washer is
in operation.
Defective
drive motor.
Disconnect the ten pin
plug from the speed control board.
Measure the resistance between pins
3 & 4 of the ten pin plug.
184 Ohms +/- 7%.
Defective speed
control board.
Readings other than
184 Ohms +/- 7%.
Drive motor tumbles very
slowly when the washer is
in operation.
Note: Always check wiring
to the components.
Note: The control board is the board in the console. The speed control board is the board in the
right rear corner.
Measure the voltage between
pin (6) of the seven pin plug and
neutral. Meter should read:
3 VAC or -163VDC in Max Spin.
35VAC or -30 VDC in Med Spin.
0.2VAC or -12VDC in Low Spin.
Defective speed
control board.
Correct readings.
Incorrect spin speed
for selected setting.
Incorrect readings.
Defective control
board.
Note: The control board is the board in the console. The speed control board is the board in the
right rear corner.
Incorrect spin speed for selected setting.
Note: Always check wiring to the components.