Service manual

57
Washer will only fill with cold
water in the wash cycle, when the
warm/cold setting is selected.
Note: Always check
wiring to the components.
Washer will only fill with
cold water in the wash
cycle, when the warm/
cold setting is selected.
Turn the faucets on.
Is the hot water faucets turned
completely on?
No.
Yes.
Using the On Line Test
activate the warm water circuit test.
Unplug the wire connector from the
hot water valve solenoid. Measure the
voltage drop between the two
terminals in the plug,
not on the valve.
120 VAC.
0.
Defective
control board.
Defective
water valve.
Washer will only fill with hot water
in the wash cycle, when the
warm/cold setting is selected.
Turn the faucets on.
Is the cold water faucets turned
completely on?
No.
Yes.
Using the On Line Test
activate the warm water circuit test.
Unplug the wire connector from the
cold water valve solenoid. Measure
the voltage drop between the two
terminals in the plug,
not on the valve.
120 VAC.
0.
Defective
control board.
Defective
water valve.
Washer will only fill with
hot water in the wash
cycle, when the warm/
cold setting is selected.
Note: Always check
wiring to the components.
Note: The control board is the
board in the console.
Note: The control board is the
board in the console.