Service manual

60
6. Disconnect the (4) wire harness plugs from the
back of the control and lift the control off.
Removing the control and display:
1. Disconnect the washer from electrical supply.
2. Remove the top and the console.
3. Release the ribbon by unlocking the ribbon connec-
tor by lifting connector about 1/4 of an inch away
from the board.
5. Remove (1) screw from each front corner and (3)
screws below the front cross brace, one on the right
side and two in the middle.
Connector in the locked possition
Connector in the unlocked possition