Service manual

3. Unplug the reed switch harness from the control

and unsnap the reed switch from the console.

Note: The replacement console and touch pad

are replaced as one part.

Removing the front service panel:

1. The front service panel is held in place by two nylon

pins at the top and two 1/4” hex screws located at

each bottom corner.

2. Remove the two 1/4" hex screws located at each

bottom corner. Pull down and forward.

4. Remove the (4) screws holding the control to the

console and the (2) screws holding display to the

console.

5. Lift the control and display off as one unit.

Removing the reed switch:

1. Disconnect the washer from electrical supply.

2. Roll the console forward.

Reed Sw.

connector