Service manual

2. Remove (2) screws which secure strike to inner

door panel.

Removing the door safety switch:

1. Disconnect washer from electrical supply.

2. Remove top panel and front service panel.

3. Reaching in from the top unplug the three connec-

tors from the door switch.

4. Remove the hinge by removing the (2) screws

holding the hinge to the inner door panel.

4. The glass is held in place by four molded tabs in the

rear door cover. To remove the glass grab the edge

of the cover by the tab and twist it away from the

glass.

5. Reinstall the glass into door frame by pressing into

place. Note locating notches on glass which en-

sures correct position.

To remove door strike:

1. Open loading door.