Service manual

68
14. Caution the consumer to wait a two hours before
using the washer to allow the adhesive enough time
to dry.
Removing the water inlet duct:
1. Disconnect the washer from electrical supply.
2. Remove the top panel and detergent dispenser
cavity.
3. Disconnect the boot from the duct.
4. Remove the two screws holding the duct to the front
panel.
5. Pull the duct to the rear and disconnect the inlet
hose.
NOTE: Reglue boot as needed.
Removing the detergent dispenser
solenoid assembly:
1. Disconnect the washer from electrical supply.
2. Remove the top panel from the washer.
3. Unplug the wires and disconnect the hoses from the
dispenser solenoid assembly.
4. Remove the two screws holding the solenoid
assembly to the detergent dispenser cavity and pull
the assembly back.
Removing the detergent cavity assembly:
1. Disconnect the washer from electrical supply.
2. Remove the top panel.
3. Remove the console panel.
4. Disconnect the vent hose.