Service manual

7. Remove the one screw from dispenser assembly.

8. Push to release catches on upper front corners and

the center of dispenser assembly and push

dispenser rearward.

Removing the pressure switch:

1. Disconnect the washer from electrical supply.

2. Remove the top panel.

3. Disconnect the wiring and the hose from the

pressure switch.

4. Remove the one screw holding pressure switch to

the top brace.

5. Remove the suspension spring retainers and

reinstall the rear screws without the spring retainer.

This will hold the control mounting panel down when

the springs are lifted. Unhook tub support springs

and move them to the next large hole back on the

side panel flange.

The springs may be removed by grasping the tub

assembly on the lower tub reinforcement area and

lifting (4:00 and 7:00 position approx.) while

guiding the top end of the spring with the other

hand to the new location. Or a simple tool may be

bent from ¼" round rod that will simplify this task.

Use the tool to hook the bottom of the spring and

lift to remove.

Spring Release Tool Bent From 1/4" Rod

6. Remove the detergent dispenser solenoid

assembly.