Service manual

70
Removing the suspension springs:
1. Disconnect the washer from electrical supply.
2. Remove the top panel.
3. Remove the two screws holding the suspension
spring retainers to the control mounting panel.
4. Reinstall the two screws to hold the mounting plate
down.
5. Detach the spring from the control mounting plate by
grasping the tub assembly on the lower tub
reinforcement area and lifting (4:00 and 7:00 position
approx.) while guiding the top end of the spring with
the other hand.
6. Rotate the spring to release it from the tub.
Removing the automatic temperature
control sensor:
1. Disconnect the washer from electrical supply.
2. Remove the top panel.
3. Unplug the harness from the sensor and disconnect
the hoses.
Removing the water inlet valve:
1. Disconnect the washer from electrical supply and
turn off the water supply.
2. Remove the top panel.
3. Disconnect the two inlet hoses.
4. Unplug the wiring harness and disconnect the outlet
hose.
5. Remove the two screws holding the valve to the
rear bar.
Removing the drain pump assembly:
1. Disconnect the washer from electrical supply.
2. Remove front access panel from washer.