Service manual

4. Remove clamp securing air bell to sump hose and

remove connecting tube from air bell.

NOTE: Seal air connecting tube to air bell and air bell

to sump hose using waterproof glue such as p/n

5364709100. DO NOT plug air connecting tube opening.

Removing the back service panel:

1. Disconnect the washer from electrical supply and

turn off the water supply.

2. Disconnect the water inlet hoses and remove the top

panel.

3. Remove the sixteen screws holding the back panel

to the top brace, sides and bottom.

Removing the speed control board

assembly:

1. Disconnect the washer from electrical supply and

turn off the water supply.

2. Remove the rear service panel.