Service manual

73
3. Unplug the two electrical plugs, remove the two
screws holding the mounting bracket to the base
and pull back and up to release the tab.
4. To remove the mounting bracket remove the three
screws, two on the side and one in the front,
holding the bracket to the assembly.
5. To remove the top plastic shield remove the two
screws holding the shield to the speed control
board assembly.
Drive belt:
The drive belt (6 rib flat Poly-V) is used to transmit power
from the motor pulley to the tub. The belt is constructed
of a material that stretches, which makes belt tension
adjustments unnecessary.
To remove or replace the drive belt:
1. Disconnect washer from electrical supply.
2. Remove rear service panel.
3. Remove belt by turning tub drive pulley and rolling belt
off pulley. The belt is elastic and is designed to "give"
enough to remove and install in this manner.
4. Reverse procedure to reinstall, making sure that belt
tracks in the center of the tub pulley. Adjust tracking,
if required, by moving belt on motor pulley.