Service manual

74
Removing the drive motor:
1. Disconnect washer from electrical supply.
2. Remove rear service panel.
3. Remove belt by turning tub drive pulley and rolling
belt off pulley. The belt is elastic and is designed to
"give" enough to remove and install in this manner.
4. Disconnect the wiring harness connector block.
5. Remove motor mounting bolts.
6. Slide motor to front while supporting to remove.
7. Reverse procedure to reinstall, making sure that
belt tracks in the center of the large pulley. Adjust
by moving belt on motor pulley if required.
Removing the large pulley:
1. Disconnect the washer from electrical supply and
turn off the water supply.
2. Remove the rear service panel and remove belt.
3. Using a 9/16” wrench Remove the bolt in the center
of the pulley by holding the pulley and turning the bolt
counter clockwise.
Removing the rear counter weight:
1. Disconnect the washer from electrical supply and
turn off the water supply.
2. Remove the top panel and the rear service panel.
3. Using a 7/16” wrench remove the two bolts holding
the weight to the back half of the outer tub.
Removing the air shock absorber:
1. Disconnect the washer from electrical supply and
turn off the water supply.
2. Remove the front and the rear service panel.
3. Remove air shock securement pins by depressing
locking tab while pulling pin to remove. This
procedure is much easier if a deep 1/2", 6 point
socket (or 13 millimeter, 6 point) is used to
compress the locking tab of the plastic pin. Push
the socket onto the tapered end of the pin as far as
it will go to compress the locking tab.