Service manual

8. Reverse procedure to reassemble using

illustration below to show outer tub screw

tightening sequence.

Removing the front counter weights:

1. Remove the outer tub.

2. Using a 7/16” wrench remove the bolts holding the

weight to the front half of the outer tub.

Removing the spin basket vanes:

There are three plastic vanes mounted to the spin basket

to aid in the washing action during the wash cycle. Two

of the vanes are secured by a screw and a tab bent into

place on the basket. To remove these vanes the spin

basket has to be removed. The third vane is secured only

by a single screw and may be removed through the door

opening.

1. Identify the vane that is located on the seam of the

spin basket and remove the mounting screw.

2. Slide vane forward toward door opening until it stops.

3. Pull vane upwards to disengage tabs on vane from

slots in spin basket.

4. Reverse procedure to replace. If screw hole on

spin basket is stripped, drive screw into other hole

on vane to secure.