Service manual

9
Resistance Ω
Electrical component @ 77° F (25°C)
Water valve solenoids 880 ± 10%
Door lock solenoid 380 ± 10%
Pump motor 15 ± 7%
Dispenser valve soleniods 1100 ± 7%
NTC Thermistor 3K - 163K
M1 TO M2 2.6 ± 7%
M2 TO M3 2.6 ± 7%
M1 TO M3 2.6 ± 7%
M5 TO M6 184 ± 7%
QUICK REFERENCE SHEET
Component resistance chart.
Water fill height 2 1/2 ± 5/8 IN. (11.75 ± 0.95 CM)
No load, start position of permanent press cycle.
Electrical requirements.
Incoming water pressure.
Drain requirements.
Motor.
Circuit - Individual, properly polarized and grounded
15 amp. branch circuit fused with 15 amp. time delay
fuse or circuit breaker.
30 and 120 pounds per square inch (maximum
unbalance pressure, hot vs. cold, 10 psi.)
Drain capable of eliminating 17 gals (64.3 L) per minute.
A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
The standpipe height above the floor should be:
Minimum height: 24 in. (61 cm)
Maximum height: 96 in. (244 cm)
Motor
Agitate wattage - Max 200
Spin wattage - Max 475