User Manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMME SELECTION
- 6. BASIC SETTINGS
- 7. BEFORE FIRST USE
- 8. DAILY USE
- 8.1 Using the detergent
- 8.2 How to select and start a programme using MY TIME selection bar
- 8.3 How to select and start the programme Pre-rinse
- 8.4 How to activate EXTRAS
- 8.5 How to start the AUTO Sense program
- 8.6 How to delay the start of a programme
- 8.7 How to cancel the delay start while the countdown operates
- 8.8 How to cancel a running programme
- 8.9 Opening the door while the appliance operates
- 8.10 The Auto Off function
- 8.11 End of the programme
- 9. HINTS AND TIPS
- 10. CARE AND CLEANING
- 11. TROUBLESHOOTING
- 12. TECHNICAL INFORMATION
- TABLE DES MATIÈRES
- 1. INFORMATIONS DE SÉCURITÉ
- 2. CONSIGNES DE SÉCURITÉ
- 3. DESCRIPTION DE L’APPAREIL
- 4. BANDEAU DE COMMANDE
- 5. SÉLECTION DES PROGRAMMES
- 6. RÉGLAGES DE BASE
- 7. AVANT LA PREMIÈRE UTILISATION
- 8. UTILISATION QUOTIDIENNE
- 8.1 Utilisation du produit de lavage
- 8.2 Comment sélectionner et démarrer un programme en utilisant la barre de sélection MY TIME.
- 8.3 Comment sélectionner et lancer le programme Pré-rinçage
- 8.4 Comment activer l'option EXTRAS
- 8.5 Comment démarrer le programme AUTO Sense
- 8.6 Comment différer le départ d'un programme
- 8.7 Comment annuler le départ différé au cours du décompte
- 8.8 Pour annuler un programme en cours
- 8.9 Ouverture de la porte au cours du fonctionnement de l'appareil
- 8.10 Fonction Auto Off
- 8.11 Fin du programme
- 9. CONSEILS
- 10. ENTRETIEN ET NETTOYAGE
- 11. DÉPANNAGE
- 12. CARACTÉRISTIQUES TECHNIQUES
11.1 The product number code
(PNC)
If you contact an Authorised Service
Centre, you need to provide the product
number code of your appliance.
The PNC can be found on the rating
plate on the appliance door. You can
also check the PNC on the control panel.
Before checking the PNC, make sure the
appliance is in the programme selection.
1. Press and hold simultaneously
and for about 3 seconds.
The display shows the PNC of your
appliance.
2. To exit the PNC presentation, press
and hold simultaneously and
for about 3 seconds.
The appliance returns to the programme
selection.
11.2 The dishwashing and drying results are not satisfactory
Problem Possible cause and solution
Poor washing results. • Refer to "Daily use", "Hints and tips" and the
basket loading leaflet.
• Use more intensive washing programme.
• Activate the ExtraPower option to improve the
washing results of a selected programme.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".
Poor drying results. • Tableware was left for too long inside the closed
appliance. Activate the function AirDry to set the
automatic opening of the door and to improve the
drying performance.
• There is no rinse aid or the dosage of rinse aid is
not sufficient. Fill the rinse aid dispenser or set the
dosage of rinse aid to a higher level.
• The quality of the rinse aid can be the cause.
• Always use rinse aid, even with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase.
Refer to "Programmes overview".
There are whitish streaks or
bluish layers on glasses and
dishes.
• The released quantity of rinse aid is too high. Ad‐
just the rinse aid dosage to a lower level.
• The quantity of detergent is too high.
There are stains and dry wa‐
ter drops on glasses and
dishes.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid dosage to a higher level.
• The quality of the rinse aid can be the cause.
The interior of the appliance
is wet.
• This is not a defect of the appliance. Humidity con‐
densates on the appliance walls.
Unusual foam during wash‐
ing.
• Use the detergent designed specifically for dish‐
washers.
• Use a detergent from a different manufacturer.
• Do not pre-rinse dishes under running water.
ENGLISH 25