User Manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMME SELECTION
- 6. BASIC SETTINGS
- 7. BEFORE FIRST USE
- 8. DAILY USE
- 8.1 Using the detergent
- 8.2 How to select and start a programme using MY TIME selection bar
- 8.3 How to select and start the programme Pre-rinse
- 8.4 How to activate EXTRAS
- 8.5 How to start the AUTO Sense program
- 8.6 How to delay the start of a programme
- 8.7 How to cancel the delay start while the countdown operates
- 8.8 How to cancel a running programme
- 8.9 Opening the door while the appliance operates
- 8.10 The Auto Off function
- 8.11 End of the programme
- 9. HINTS AND TIPS
- 10. CARE AND CLEANING
- 11. TROUBLESHOOTING
- 12. TECHNICAL INFORMATION
- TABLE DES MATIÈRES
- 1. INFORMATIONS DE SÉCURITÉ
- 2. CONSIGNES DE SÉCURITÉ
- 3. DESCRIPTION DE L’APPAREIL
- 4. BANDEAU DE COMMANDE
- 5. SÉLECTION DES PROGRAMMES
- 6. RÉGLAGES DE BASE
- 7. AVANT LA PREMIÈRE UTILISATION
- 8. UTILISATION QUOTIDIENNE
- 8.1 Utilisation du produit de lavage
- 8.2 Comment sélectionner et démarrer un programme en utilisant la barre de sélection MY TIME.
- 8.3 Comment sélectionner et lancer le programme Pré-rinçage
- 8.4 Comment activer l'option EXTRAS
- 8.5 Comment démarrer le programme AUTO Sense
- 8.6 Comment différer le départ d'un programme
- 8.7 Comment annuler le départ différé au cours du décompte
- 8.8 Pour annuler un programme en cours
- 8.9 Ouverture de la porte au cours du fonctionnement de l'appareil
- 8.10 Fonction Auto Off
- 8.11 Fin du programme
- 9. CONSEILS
- 10. ENTRETIEN ET NETTOYAGE
- 11. DÉPANNAGE
- 12. CARACTÉRISTIQUES TECHNIQUES
3.1 Beam-on-Floor
Beam-on-Floor is a light displayed on the
floor below the appliance door.
• When the programme starts, a red
light comes on and stays on for the
duration of the programme.
• When the programme is completed, a
green light comes on.
• When the appliance has a
malfunction, the red light flashes.
Beam-on-Floor is off when
the appliance is deactivated.
When AirDry is activated
during the drying phase, the
projection on the floor may
not be completely visible. To
see if the cycle is finished,
check the control panel.
3.2 Internal light
The appliance has an internal lamp. It
comes on when you open the door or
switch the appliance on while the door is
open.
The lamp goes off when you close the
door or switch the appliance off.
Otherwise, it goes off automatically after
some time to save energy.
4. CONTROL PANEL
1 2 3
4 5 6
1
On/Off button / Reset button
2
Delay Start button
3
Display
4
MY TIME selection bar
5
EXTRAS buttons
6
AUTO Sense program button
4.1 Display
A
CB B
A. ECOMETER
B. Indicators
C. Time indicator
4.2 ECOMETER
The ECOMETER indicates how the
programme selection impacts energy
and water consumption. The more bars
are on, the lower the consumption is.
indicates the most
environmentally friendly programme
selection for a normally soiled
dishwashing load.
ENGLISH 7