User Manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMMES
- 6. OPTIONS
- 7. SETTINGS
- 8. BEFORE FIRST USE
- 9. DAILY USE
- 10. HINTS AND TIPS
- 11. CARE AND CLEANING
- 12. TROUBLESHOOTING
- 13. TECHNICAL INFORMATION
- INHALTSVERZEICHNIS
- 1. SICHERHEITSHINWEISE
- 2. SICHERHEITSANWEISUNGEN
- 3. PRODUKTBESCHREIBUNG
- 4. BEDIENFELD
- 5. PROGRAMME
- 6. OPTIONEN
- 7. EINSTELLUNGEN
- 8. VOR DER ERSTEN INBETRIEBNAHME
- 9. TÄGLICHER GEBRAUCH
- 10. TIPPS UND HINWEISE
- 11. REINIGUNG UND PFLEGE
- 12. PROBLEMBEHEBUNG
- 13. TECHNISCHE DATEN
initiation has no impact on the cycle
duration, unless it occurs in the middle of
a programme or at the end of a
programme with a short drying phase. In
such cases, the regeneration prolongs
the total duration of a programme by
additional 5 minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin
in the same cycle or at the beginning of
the next programme. This activity
increases the total water consumption of
a programme by additional 4 litres and
the total energy consumption of a
programme by additional 2 Wh. The
rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible
more than one in the same cycle) may
prolong the programme duration by
another 5 minutes when it occurs at any
point at the beginning or in the middle of
a programme.
All the consumption values
mentioned in this section are
determined in line with the
currently applicable standard
in laboratory conditions with
water hardness 2.5mmol/L
(water softener: level 3)
according to the regulation:
2019/2022 .
The pressure and the
temperature of water as well
as the variations of the
mains supply can change
the values.
How to set the water softener
level
Make sure the appliance is in user mode.
1. Press .
• The indicator still flashes.
• The remaining indicators are off.
• The display shows the current
setting: e.g. = level 5.
2. Press repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
7.3 The rinse aid level
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
You can set the released quantity of
rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Factory setting: level 4.
When the rinse aid chamber is empty,
the rinse aid indicator is on, notifying to
refill rinse aid. If the drying results are
satisfactory while using multi-tablets only,
you can deactivate the dispenser and the
indicator. However, for the best drying
performance, always use rinse aid and
keep the rinse aid indicator active.
To deactivate the rinse aid dispenser and
indicator, set the level of rinse aid to 0.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicator still
flashes.
• The remaining indicators are off.
• The display shows the current
setting: e.g. = level 4.
2. Press
repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
7.4 AirDry
AirDry improves the drying results with
less energy consumption. The appliance
door opens automatically during the
drying phase and remains ajar.
ENGLISH 13