User manual

•
Hissing, buzzing
3
The device is fitted with a fan for cooling
the electrics. A whiring noise can be heard
when operating the fan which may deviate
depending on the performance and may
continue for a while after the appliance is
switched off.
The noises described are normal and do
not refer to any defects.
Installation Instructions
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and
standards in force in the country of use
are to be followed (safety regulations,
proper recycling in accordance with the
regulations, etc.)
Installation may only be carried out by a
qualified electrician. The minimum dis-
tances to other appliances and units are
to be observed.
Anti-shock protection must be provided
by the installation, for example drawers
may only be installed with a protective
floor directly underneath the appliance.
The cut surfaces of the worktop are to
be protected against moisture using a
suitable sealant.
The sealant seals the appliance to the
work top with no gap. When building in,
protect the underside of the appliance
from steam and moisture, e.g. from a
dishwasher or oven.
Avoid installing the appliance next to
doors and under windows. Otherwise
hot cookware may be knocked off the
rings when doors and windows are
opened.
Warning! Risk of injury from electrical
current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by in-
stalling correctly.
• The appliance must be connected to
the electrical supply by a qualified
electrician.
• Loose and inappropriate plug and
socket connections can make the ter-
minal overheat.
• Have the clamping connections cor-
rectly installed by a qualified electri-
cian.
• Use strain relief clamp on cable.
• In the event of single-phase or two-
phase connection, the appropriate
mains cable of type H05BB-F Tmax
90°C (or higher) must be used.
• If this appliance’s mains cable is dam-
aged, it must be replaced by a special
cable (type H05BB-F Tmax 90°C; or
higher). Please contact your local
Service Force Center for further ad-
vice.
A device must be provided in the elec-
trical installation which allows the appli-
ance to be disconnected from the mains
at all poles with a contact opening width
of at least 3 mm
Suitable isolation devices include line
protecting cut-outs, fuses (screw type
fuses are to be removed from the hold-
er), earth leakage trips and contactors.
Sticking on the seal
• Clean the worktop in the area of the cut-
out section.
• Stick the one-sided self-adhesive sealing
tape supplied all the way round the lower
edge of the cooking surface along the out-
er edge of the glass ceramic panel. Do not
stretch it. The cut ends should lie in the
middle of one side. When you have cut it
to length (add a few mm), press the two
ends flush up against one another.
Sticking the seal to the rabbet
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive sealing
tape supplied onto the upper surface of
the rabbet along the edges of the cut-out
section.
• Cut the sealing tape into four pieces relat-
ing to the length of the edges of the rabbet.
14 electrolux