User Manual

6
www.electrolux.com
4. CONTROLS
      
Button
Basic function
Indicator lights
Dual Function
L
Press briey to turn the lighting system on and off. Button off Lights off
Press and hold the button for 2 seconds to activate the lighting
system in “courtesy light” mode. The lights are lit at a reduced
power of approximately 5W. This function can be disabled by
pressing the button once again for 2 seconds or by pressing it
briey to switch to normal lighting mode.
Button lit Lights on
Button lit Courtesy light on
T1
Turns the motor off from whatever speed it is set to.
Button lit Motor active
Motor inactive
Press and hold the button for 3 seconds with all the loads turned off
(Motor and Lights), to turn the Activated Charcoal Filter alarm on/off.
Button ashes twice F – Alarm On.
Button ashes once F – Alarm Off.
T2 Turns the motor on at speed one. Button on
T3
When pressed briey, turns the motor on at speed two. Button on Speed two on
Press and hold the button for approximately 2” to turn the Delay
function on and off, that is to say to turn the appliance off after a
20 minute delay. Suitable to complete elimination of residual odours.
Can be activated from the OFF position and from speeds 1, 2, 3.
Cannot be activated with Intensive speed On.
Buttons flashing
(T1+T2 or T3 or
T4)
Delay functionActive
T4 Turns the motor on at speed three. Button on
T5
Turns the motor On and Off at Intensive speed for a timed
period of 5 minutes. At the end of the 5 minutes the appliance
will automatically return to the speed that was set before. If
the appliance was turned off at the time of activation, at the
end of the 5 minutes the system will return to speed one.
Button on
F
Press and hold for 4 seconds to reset the lter alarm
indicator, shown by ashing of button T1. This procedure
can only be carried out with the motor off.
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it
is necessary to wash the lters.
The alarm is triggered after the
Hood has been in operation for
100 working hours.
Button ashing
When this is activated, it
signals the Activated Char-
coal Filter saturation alarm,
indicating that the lter must
be changed; the Metal Grease
Filters must also be washed.
The Activated Charcoal Filter
saturation alarm comes into
operation after the Hood has
been working for 200 hours.
5. LIGHTING
• For replacement contact tech-
nical support (“To purchase
contact technical support”).