User manual

64 electrolux
GB
GB
Clean the melting water outlet with the
supplied pipe scraper that can be seen in
the figure. The pipe scraper has to be
stored in the outlet.
Occasionally check the defrost water
outlet not to be clogged up.
The most typical case of clogging up in
the defrost water outlet when you put
food wrapped in some paper into the
appliance and this paper contacts back
plate of cooling compartment and
freezes to it. If you remove the food right
at this moment the paper will tear and it
can cause clogging up in the outlet by
getting into it. So you are asked to be
careful - because of the above - when
placing foods wrapped in paper into the
appliance.
In case of increased demand e.g.
during heatwaves, the refrigerator
temporarily happens to operate
constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on
back plate of the cooling compartment
after defrosting period is not abnormal.
Regular cleaning
It is recommended to wash the inside of
the refrigerator in 3-4 weeks time.
Household cleaner or soap must not be
used.
After you made it no-current wash the
appliance using lukewarm water and
wipe it.
Clean the magnet door rubber profile
with clean water.
After cleaning plug the appliance to the
mains socket.
Dust and dirt collected on the back of the
refrigerator, condenser is recommended
to be removed and clean the evaporative
tray on top of the compressor once or
twice a year.
When the refrigerator is not in use
In case the appliance will not be used for
a long time follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up
of air inside.
How to change the bulb
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing
screw.
3. Unhook the moving part by pressing it
as shown in the figure.
4. Replace the bulb with one of the same
power (the maximum power is shown
on the light bulb cover)
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light
comes on.