User manual

12.5 Activating a cleaning
function
1. Activate the appliance.
2. Touch
until the display showsS1.
In some models you can also choose
S2, S3, S4.
3. Touch or to select a cleaning
function.
4. Touch to confirm.
12.6 Tank Emptying - S1
Remove all accessories.
The cleaning function removes the
residual water from the water drawer.
Use the function after the steam cooking
function.
The duration of the function is around 6
minutes.
The light in this function is off.
1. Put the tray on the first shelf position.
2. Activate Tank Emptying function -
S1. Refer to "Activating a cleaning
function".
3. Touch
.
Remove the baking tray after the end of
the procedure.
12.7 Steam Cleaning - S2
Remove as much dirt as possible
manually.
Remove the accessories and the shelf
support to clean the side walls.
The steam cleaning functions support the
steam cavity cleaning of the appliance.
For a better performance
you should start the cleaning
function when the appliance
is cool.
The specified time is related
to the duration of the
function and does not
include the time required for
cleaning of the cavity by the
user.
When the steam cleaning function is
active, the lamp is off.
1. Fill the water drawer to the maximum
level (around 950 ml of water) until
the acoustic signal sounds or the
display shows the message.
2. Activate Steam Cleaning function -
S2. Refer to "Activating a cleaning
function".
The duration of the function is around
30 minutes.
An acoustic signal sounds when the
programme is completed.
3. Touch a sensor field to deactivate the
signal.
4. Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water to clean the cavity.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. Let the appliance
dry fully with the door open. To speed up
the drying you can close the door and
heat up the appliance with True Fan
Cooking at temperature 150°C for
approximately 15 minutes. You can get
maximum effects of the cleaning function
if you manually clean the appliance
immediately after the function ends.
Repeat the procedure a second time if
the level of dirt is high.
12.8 Cleaning Reminder
This function reminds you that the
cleaning is necessary and that you
should perform the function: S2.
You can enable / disable this function in
the settings menu.
12.9 Steam generation system
- Descaling - S3
When the steam generator operates,
there is an accumulation and deposition
of limestone inside because of calcium
contents in the water. This can have a
negative effect on the steam quality, on
the performance of the steam generator
and on the food quality. To prevent this,
clean the steam generation circuit from
residual stone.
ENGLISH 43