User manual

10.7 Starting a programme
without the delay start
Press the Avvio/Pausa button.
• The green Avvio/Pausa indicator
stops flashing and stays on.
• The programme starts, the door
locks, the indicator
illuminates
and stays on.
• The programme time on the
display decreases with steps of
one minute.
The drain pump can operate
for a short time at the
beginning of the washing
cycle.
10.8 Interrupting a programme
and changing the options
You can change only some options
before the programme carries them out.
1. Press the Avvio/Pausa button to
interrupt the running programme.
The related indicator flashes.
2. Change the options (if you wish to
change the Time Manager option,
you must cancel the running
programme and make your selection
again).
3. Press the Avvio/Pausa button again.
The programme continues.
10.9 Cancelling a running
programme
1. Turn the programme knob to
position to cancel the programme.
The appliance is deactivated.
2. Now, you can set a new washing
programme and the available
options.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment; if
not, fill the detergent again.
10.10 Opening the door
While a programme is running or during
the Partenza Ritardata, the appliance
door is locked. The indicator
is on.
CAUTION!
If the temperature and level
of the water in the drum are
too high and the drum still
rotates, you cannot open the
door.
To open the door during the first minutes
of the cycle or when the Partenza
Ritardata operates:
1. Press the Avvio/Pausa button to
pause the appliance.
2. Wait until the indicator
goes off.
3. You can open the door.
4. Close the door and press the Avvio/
Pausa button again.
The programme (or the Partenza
Ritardata) continues.
10.11 At the end of the
programme
• The appliance stops automatically.
Some acoustic signals sound (if they
are activated).
• In the display the value come
on. The Avvio/Pausa indicator goes
off.
• When the door lock indicator goes
off, you can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty. Close the water tap.
• Turn the programme knob to
position to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door lock indicator is on. The
door stays locked.
• You must drain the water to open the
door.
www.electrolux.com18