User manual

CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1. Wipe out the cavity with a wet, soft
cloth.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Daily use" chapter, "Oven
Functions".
4. When flashes, press or to
set the pyrolysis duration:
Option Description
P1 Light clean‐
ing. Duration:
1 h.
P2 Normal
cleaning. Du‐
ration: 1 h 30
min.
Press or turn the knob for the
temperature to start the pyrolysis.
You can use the END function to delay
the start of the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set
temperature, the door locks. The
display shows and the bars of the
heat indicator until the door unlocks.
To stop pyrolysis before it is
completed, turn the knob for the oven
functions to the off position.
6. When pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the oven is cool again, the
door unlocks.
11.5 Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
The cleaning reminder
goes out:
• after the end of the
pyrolysis.
• if you press and at
the same time while PYR
flashes in the display.
11.6 Removing and installing
door
The oven door has three glass panels.
You can remove the oven door and the
internal glass panels to clean them.
Read the whole "Removing and installing
door" instruction before you remove the
glass panels.
The oven door may close if
you try to remove the glass
panels before you remove
the oven door.
CAUTION!
Do not use the oven without
the glass panels.
1. Open the door fully and hold both
hinges.
2. Lift and turn the levers fully on both
hinges.
ENGLISH 25