INSTRUCTIONS FOR USE ........................... Page 3 MODE D'EMPLOI GEBRUIKSAANWIJZING ..
Bottled Gas Operation - Lighting the burner INTRODUCTION To ensure satisfactory and economical operation, it is essential that the refrigerator is installed as directed in the Electrolux Installation Instructions, and is used in accordance with these instructions. The ventilation openings for air circulation over the cooling unit must not be reduced in size or obstructed in any way otherwise the performance of the cooling unit may be impaired and consumption increased.
TEMPERATURE REGULATION After starting up the refrigerator, it will take about an hour before there are signs of cooling. When operating on mains voltage electricity, the refrigerator is thermostatically controlled and the thermostat knob (6) should be set to No. 3 or 4. This will maintain a suitable temperature in the refrigerator and frozen food storage compartment for general use but, in hot weather, or if more cooling is required, the knob should be turned to a higher number.
4 . R e m o ve s c r e w h o l d i n g b u r n e r b r a c k e t ( 1 1 ) t o b o i l e r , r e l e a s e bracket tongues from slot in boiler, then carefully move burner bracket assembly to one side, clear of the flue tube. 5 . Clean burner and adjacent components of soot etc. without dis turbing their relative positions. 6. Clean flue tube of boiler - a special flue brush (part No. 151404) is available as an extra for this purpose. 7 .
