User manual

59
GBGB
Remaining small ice and frost stains on back plate of the
refrigerator after defrosting period is not abnormal.
Defrosting of the freezer is automatic in this model.
Regular cleaning
Clean the equipment regularly.
Don't use detergents, abrasive or strongly
odorous cleaners, waxy polishing agents or
disinfectants or alkoholic products for cleaning the
equipment.
Before cleaning pull out the wall plug of the equipment
from the outlet.
Internal cleaning
Clean the internal parts of the equipment and the acces-
sories with warm water and sodium bicarbonate (5 ml to
0.5 litre of water).
Rinse and dry everything thoroughly.
Clean the door seal profile with clean water.
External cleaning
Clean the external parts of the equipment with warm water
and sodium bicarbonate (5 ml to 0.5 litre of water).
It is recommended to remove the dust and dirt deposited
on the back side of the equipment and on the condenser
once or twice a year, and to clean the evaporation tray on
top of the compressor.
After cleaning, reconnect the equipment to the mains sup-
ply.
When the refrigerator is not in use
In case the appliance will not be used for a long time fol-
low these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the
cover in the direction indicated by the arrow (2). So the
bulb can be replaced. (Bulb type: T 25 230-240 V, 25 W,
E 14 thread)
After changing the bulb replace the cover, snap it in place
and apply voltage to the appliance.
If something does not work
During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
We draw it to your attention again that the appliance
operates discontinuously, so the stopping of com-
pressor does not mean being no-current. That is why you
must not touch the electrical parts of the appliance before
breaking the circuit.