Installation manual

11
Setup
Setup
Unpacking
When unpacking the machine, handle it with
care.
The drum has no transport clamps.
Fastened to the pallet
The dryer is fastened to the pallet by two bolts.
Openthelterdrawerandthenremovethefront
bolt.
Remove the back plate and then remove the
back bolt.
Tumbler type 4250
From factory the dryer is equipped with 4 sup-
porting feet (a).
Dryer type 4250 must be installed with all 6 sup-
porting feet mounted (a+b).
The last 2 feet (b) are temporarely mounted
at the bottom on the back of the back cover.
Unscrew the feet and carefully tilt the dryer for-
ward and then demount the 2 feet (b).
The last 2 feet are monted in order to stabilize
the machine.
Tumbler type 4350
From factory the dryer is equipped with 4 sup-
porting feet (a).
Positioning
Place the tumble dryer in such a way that work
can be done as easily as possible by the user
and the service technician alike.
The distance to the wall or other equipment be-
hind the dryer should be min. 500 mm.
Apartfromtheminimumdistancesshownong.
1 there are no further requirements to the dis-
tance around the dryer.
However, there should be free access to the
back of the dryer for the purpose of servicing it.
The door hanging can be changed.
W00054
1
1
1
1
500 mm
A
A
Min.150 mm
Max. 50 mm
A - A
B
A