Installation manual

14
Installation
W00057, W00058
2
2
Up to machine No. T4250 –4250/101239
T4350 –4350/100824
Reversing door
The loading door is reversible if it does not open
to the desired side.
Reversing
1. Disconnect the power supply to the dryer.
2. Open the operating panel.
 3.Demountthelterdoor.
4. Unscrew the door and the front panel.
5. Unscrew the cover plate.
 6.Demountthemicroswitchwithttings.
7. Squeeze out the black strip which is mounted
in the back plate of the component unit
8. Run the cables including the black strip behind
the back plate and across the drum.
9. The black strip must be mounted in the hole
on the opposite side.
10. Unscrew the micro switch holder. Un -
screw the micro switch from the holder,
reverse it and mount it in the holder in
the same order as before.
11. Move dummy plugs B in the side panel to the
opposite side.
12. Mount holder with micro switch on the oppo-
site side, use holes C.
13. Move speed nuts to the opposite side.
14. Mount the cover plate.
15. Check that all 4 terminal strips are
mounted on the casing.
16. Reverse the front panel and the door and then
mount them.
Check that the felt joint is in good condition.
 17.Closetheoperatingpanelandmountthelter
door.
18. Unscrew the door pin and move it to position
A.
3
W00056
B
B
C
C
Micro switch
right
Micro switch
left
3