Installation manual

33
Installation
Conversion instructions - T4350 only:
1. Disconnect the power to the dryer.
2. Remove the back plate.
3. Remove the screw on the side of the locking
plate x, see Fig. 5.
4. Pull out the locking plate x, this releases the
gas pipe, see Fig. 5.
5. Remove the nozzle.
6. Turn the pipe a little and mount the supplied
gas nozzle, see Fig. 2.
7. Push pipe with new nozzle back into its place.
8. Push locking plate all the way in and tighten
the screw.
9. Replace/mount air reducing plate according to
table, see Fig. 2. All air reducing plate types
are shown in Fig. 6.
10. Loosen the measuring branch screw (2) 1/4
turn; connect a manometer to the measuring
branch (2), see Fig. 4.
11. Connect the power and select a programme
with heat.
12. Start the dryer.
13. See nozzle pressure in table Fig. 2 - set the
nozzle pressure on setting screw (4) under
cover screw (3), see Fig. 4.
 14. Checkthatthegasameburnsevenlyandhas
a bluish colour.
15. Mount the cover screw (3), see Fig. 4.
16. Mount the back plate.
NOTE: After the conversion has been carried
out, the enclosed sign with the new gas type
printed on it mustbeafxedtothedryerdata
plate, see instructions on the last page.
x
W00072
W00071
2
4+3
1
4
5