Installation manual

35
Installation
Electric installation - electric/gas/
steamheated
The tumble dryer must be connected to its
own fuse group and pulti-pole main switch
according to IEC 60947.
Connecting the cable
Demount the cover plate from the supply unit.
The cable is led through the cable gland to the
terminal block and connected as illustrated.
If there is a neutral conductor in the power
supply line this must be connected to terminal
N:
Electrical heated with supply
disconnector
Electrical heated
Gas and steam heated
Gas and steam heated with supply
disconnector
Cable dimension
For calculation of the connection cable
dimension, please refer to local guidelines.
Fuse group and effect
The sizes of the fuse group and the effect are
shown on the following page.
Function check
The function check is described in the back of
this manual.
NB: Correct direction of rotation is important!
The tumble dryer must be equipped with
supplementary protection in accordance
with heavy current regulations.
To be carried out by qualied personnel
W00077
1
2
3
4
W00078
W00079
W00080
L1
L2
L3
N
L1
L2
L3
N
1
2
3
4