User manual

FITTING AND MOUNTING TO CONTINUOUS WORKTOP
Before fitting, change the door opening di-
rection if necessary (see: Door reversibility).
• Push the appliance carefully into the ni-
che.
• Take care that the mains cable is not
jammed in.
• Check distance from wall (see: Installing
under a continuous worktop).
• Level the appliance by screwing the two
adjustable feet at the front in or out, thus
ensuring a stable position.
• With a suitable screws (depending on
the design of the worktop and the dis-
tance between the appliance and the
worktop, not supplied), fix the appliance
under the worktop through the upper
door hinge. If necessary, equalize the
gap between the door hinge and the
worktop with a suitable washer (plastic
or wood, not supplied). This will prevent
bending of the hinge and possible failure
of door function.
DOOR REVERSIBILITY
To carry out the following opera-
tions, we suggest that this be
made with another person that will
keep a firm hold on the doors of
the appliance during the opera-
tions.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that
the compressor cannot touch the floor.
• Unscrew the left foot.
• Unscrew the screws of the door bottom
hinge.
• Take off the appliance door by pulling it
slightly downwards.
16
www.electrolux.com