User manual

BUZZER (Signal) permanent
off
1. Turn the programme selector to any pro-
gramme.
2. Press simultaneously the DELICATE (Schon)
and SENSITIVE (Sensitiv) buttons and hold
down for approx. 5 seconds the result can
be following:
– diode above BUZZER (Signal) button
starts lighting - BUZZER (Signal)
permanently on.
– lighting diode comes off - BUZZER (Sig-
nal) permanently off.
3. The buzzer is by default always off. You can
use BUZZER (Signal) button to activate or
deactivate sound but machine does not
memorize your selection.
Water hardness
Water contains, a variable
quantity of limestone and
mineral salts of which quan-
tities vary according to
geographical locations thus
varying its conductivity val-
ues.
Relevant variations of the
conductivity of the water
compared to those prefixed
by the factory could slightly
influence the residual
humidity of the laundry at
the end of the cycle. Your
dryer allows you to regulate
the sensitivity of the drying
sensor based on
conductivity values of the
water.
1. Turn the programme selector to any pro-
gramme.
2. Press simultaneously the DELICATE (Schon)
and TIME (Zeitwahl) buttons and hold down
for approx. 5 seconds. The current setting is
on the display:
–
low conductivity <300 micro S/cm
–
medium conductivity 300-600 mi-
cro S/cm
–
high conductivity >600 micro S/
cm
3. Press the START PAUSE (Start/Pause) but-
ton sequentially until you set desired level.
4. To memorize setting press simultaneously
the DELICATE (Schon) and TIME (Zeitwahl)
buttons or turn knob to OFF (Aus) position
34 electrolux machine settings