User manual

The symbol comes into the view on the
display.
5. To deactivate the child lock, push
again the above buttons until the
symbol goes out of the view.
9.8 Buzzer (Signal) option
When the buzzer option is activated you
can hear the sound at the:
• cycle end
• anti-crease phase start and end
• cycle interruption
The buzzer option is by default always on.
You can use this option to activate or
deactivate the sound.
You can activate the Buzzer
(Signal) option with all
programmes.
To activate/deactivate the Buzzer
(Signal) option:
Push at the same time and hold down the
Anti-crease (Knitterschutz) and Time
Save (Zeit Sparen) buttons.
The acoustic signal sounds to confirm the
change.
9.9 Starting a programme
To start the programme:
Push the Start/Pause button.
The appliance starts and the LED above
the button does not flash but is stable.
9.10 Programme change
To change a programme:
1. Push the On/Off (Ein/Aus) button to
turn off the appliance.
2. Push again the On/Off (Ein/Aus)
button to turn on the appliance.
3. Set a new programme.
9.11 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol flashes on the display. If the
Buzzer (Signal) option is on, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
10. HINTS AND TIPS
10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
www.electrolux.com16