User manual

11.5 Cleaning the control panel
and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion to
clean the appliance.
11.6 Cleaning the airflow slots
Use a vacuum cleaner to remove the fluff
from the airflow slots.
12. TROUBLESHOOTING
Problem
1)
Possible cause Remedy
The tumble dry-
er does not op-
erate.
The tumble dryer is not connec-
ted to mains supply.
Connect in at mains socket.
Check fuse in fuse box (domestic
installation).
The loading door is opened. Close the loading door.
The On/Off (Ein/Aus) button was
not pushed.
Push the On/Off (Ein/Aus) button.
The Start/Pause button was not
pushed.
Push the Start/Pause button.
The appliance is in the standby
mode.
Push the On/Off (Ein/Aus) button.
Unsatisfactory
drying result.
Incorrect programme selection. Do the selection of the applicable
programme.
2)
The filter is clogged.
Clean the filter.
3)
The Dry Plus (Trocken+) option
was in minimum level.
4)
Change the Dry Plus (Trocken+)
option to the moderate or maxi-
mum level.
4)
Too high volume of the load. Obey the maximum load volume.
The airflow grill is clogged. Clean the airflow grill in the bot-
tom of the appliance.
Dirt on the humidity sensor in the
drum.
Clean the front surface of the
drum.
Incorrect remaining laundry mois-
ture degree.
Adjust remaining laundry moisture
degree.
5)
The heat exchanger is clogged.
Clean the heat exchanger.
3)
www.electrolux.com20