User manual

11.7 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (3) of
'To clean the drain filter'.
If necessary, clean the filter.
Put the drainage duct back and close the
drain filter flap.
11.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than 0
°C, remove the remaining water from the
inlet hose and the drain pump.
1.
Close the water tap and disconnect
the inlet hose.
2.
Put the end of the inlet hose in a con-
tainer and let the water flow out of the
hose.
3.
Do the Drain programme and let it
operate until the end of the cycle.
4.
Turn the programme knob to Stop to
disconnect the appliance from the
power supply.
5.
Disconnect the appliance.
WARNING!
Make sure that the temperature is
more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
12. TROUBLESHOOTING
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the serv-
ice centre.
With some problems, the acoustic
signals operate and the display
shows an alarm code:
•
- The appliance does not fill with
water.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Problem Possible cause Possible solution
The appliance
does not fill with
water.
The water tap is closed. Open the water tap.
The water inlet hose is
damaged.
Make sure that the water inlet
hose has no damages.
The filters in the water in-
let hose is blocked .
Clean the filters. Refer to 'Care
and cleaning'.
The water tap is blocked
or is furred with lime-
scale.
Clean the water tap.
The connection of the
water inlet hose is not
correct.
Make sure that the connection is
correct.
The water pressure is
too low.
Contact your local water authori-
ty.
20
www.electrolux.com