User manual

Problem Possible cause Possible solution
The water drain hose is
damaged.
Make sure that the water inlet
hose has no damages.
You cannot open
the appliance
door.
The washing programme
is in operation.
Let the washing programme end.
There is water in the
drum.
Set the drain or the spin pro-
gramme.
The appliance
makes an unusual
noise.
Incorrect level of the ap-
pliance.
Adjust the level of the appliance.
Refer to 'Installation'.
You did not remove the
packaging and/or the
transit bolts.
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
The load is very small. Add more laundry in the drum.
The appliance fills
with water and
drain immediately.
The end of the drain
hose is too low.
Make sure that the drain hose is
in the correct position.
The washing re-
sults are not satis-
factory.
The detergent you used
was not sufficient or cor-
rect.
Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry.
Use special products to remove
the stubborn stains.
Incorrect temperature
was set.
Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
13. TECHNICAL INFORMATION
Dimensions Width / Height / Depth 400 / 890 / 600 mm
Total depth 600 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
22
www.electrolux.com