Quick Guide

THE PROSENSE LOAD DETECTION
After the programme start and before the water lling, the
appliance estimates the laundry amount in 30 seconds. The
and indicators ash. After load estimation, the programme
duration is updated accordingly on the display.
If the drum is overloaded, the display shows the maximum load
and
ashes. In this case, for further 30 seconds it is
possible to pause the appliance and remove a few garments.
If the laundry amount is not reduced, the appliance starts the washing
programme immediately despite the overload (for more information
see the User manual).
ALARM CODES
The display can show alarm codes (refer to the “Troubleshooting”
table in the user manual):
:
The appliance does not ll water properly.
:
The appliance does not drain the water.
:
The appliance door is open or not closedcorrectly.
:
The anti-ood device is on. Disconnect the appliance and
close the water tap. Contact the Authorised service centre.
MIX
Maximum load indicator
Maximum laundry indicator, it ashes in case of
overloading.
Door lock indicator and child lock indicator
Delay start indicator
This area can shows: the programme duration
(e.g. ), the delay time (e.g. ), the cycle end ( ),
the warning code (e.g. )
Phase indicators:
Washing Rinse
Soft Plus Spin
Anticrease Steam
MIX
OKO-MIX (if available)
Energy saving indicators. appears if selecting a
cotton programme at 40°C or 60°C
Time save indicator
Spin speed indicator
Rinse Hold indicator and Extra Silent indicator
Temperature indicator and Cold wash indicator
INTERACTIVE DISPLAY