User manual

Problem Possible solution
The appliance makes
an unusual noise.
Make sure the levelling of the appliance is correct. Refer to
"Installation".
Make sure that the packaging and/or the transit bolts are
removed. Refer to "Installation".
Add more laundry in the drum. The load may be too small.
The cycle is shorter
than the time displayed.
The appliance calculates a new time according to the laun‐
dry load. See the "Consumption Values" chapter.
The cycle is longer than
the time displayed.
An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
The washing results are
not satisfactory.
Increase the detergent quantity or use a different deter‐
gent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
You cannot set an op‐
tion.
Make sure that you press only the wanted button(s).
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
14. TECHNICAL DATA
Dimension Width/ Height/ Depth/
Total depth
400 mm/ 890 mm/ 600 mm/ 600
mm
Electrical connection Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
IPX4
Water supply pressure Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum Load Cotton 6 kg
ENGLISH 27