User manual

duration of the anti-crease and
the cooling phases.
2. Press to start the programme.
• The display shows regularly a
new time value.
• The drying indicator starts to
flash.
• The display shows the door
locked indicator .
If you set only 10 minutes of
drying, the appliance
performs only a cooling
phase.
If the laundry is not sufficient
dry, set again a short drying
time.
11.4 End of the drying
programme
The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display comes on.
• The indicator goes off.
• The last minutes of the drying cycle
the appliance performs a cooling and
anti-crease phase. The door is still
locked.
When the door locked
goes off in the
display, you can open the door.
1. Press the button for some
seconds to deactivate the appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew
and odours.
4. Close the water tap.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
12.1 Non-Stop programme
1. Press On/Off for some seconds to
activate the appliance.
2. Load the laundry one item at a time.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
12.2 Washing & Automatic
drying
1. Press again and again until the
display shows one of the dryness
level indicator:
• : IRON DRY level indicator for
cotton items
•
: CUPBOARD DRY level
indicator for cotton, synthetic,
wool and silk items
• : EXTRA DRY level indicator
for cotton items
The display shows the indicator . The
time value on the display is the duration
of the washing + drying cycles,
calculated on a default load size.
To have a good drying the
appliance does not let you
set a too low spin speed for
the items to be washed and
dried.
2. Press to start the programme.
ENGLISH 21