User manual

7.7 Activating the appliance
Press the button to activate the
appliance.
The led of the button starts flashing.
The appliance proposes the programme
as default programme.
7.8 Setting a programme
Press the desired programme button.
In the display, the washing temperature,
the spin speed and the time to end
change accordingly, e.g:
7.9 Coin operated machine
Insert the correct amount of coins as
shown in the appliance display.
Press the button to start the
appliance.
The display shows the
message if the
washing cycle has not been
paid yet.
7.10 Starting a programme
Press the button .
• The indicator of the button
stops flashing and stays on.
• The indicator of the running phase
starts flashing on the display.
• The programme starts and the
door locks.
• The drain pump can operate for a
short time when the appliance fills
water.
After approximately 15
minutes from the start of the
programme:
• The appliance can adjust
the programme duration
automatically depending
with the laundry load.
• The display shows the
new time to end.
7.11 Cancelling a running
programme
1. Press the button for some seconds
to cancel the programme and to
deactivate the appliance.
WARNING!
If the appliance has already
uploaded water, the door
remains locked.
2. Press the same button again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
www.electrolux.com14