User manual

To clean the water inlet filters:
1.
Close the water tap.
2.
Remove the water inlet hose from the
water tap.
3.
Clean the filter in the inlet hose with a
stiff brush.
4.
Remove the inlet hose behind the ap-
pliance.
5.
Clean the filter in the valve with a stiff
brush or a towel.
45°
20°
6.
Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
7.
Open the water tap.
13.9 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (6) of
'To clean the drain pump'.
If necessary, clean the pump.
Put the drainage duct back and close the
drain pump flap.
When you drain the water with the emer-
gency drain procedure, you must activate
again the drain system:
1.
Put 2 litres of water in the main wash
compartment of the detergent dis-
penser.
2.
Start the programme to drain the wa-
ter.
13.10 Frost precautions
If the appliance is installed in an area
where the temperature can be less than 0
°C, remove the remaining water from the
inlet hose and the drain pump.
1.
Disconnect the mains plug from the
mains socket.
2.
Close the water tap.
3.
Remove the water inlet hose
4.
Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5.
Empty the drain pump. Refer to the
emergency drain procedure
6.
When the drain pump is empty, install
the inlet hose again.
WARNING!
Make sure that the temperature is
more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
ENGLISH 27