User manual

Problem Possible cause Possible solution
The washing re-
sults are not satis-
factory.
The detergent you used
was not sufficient or cor-
rect.
Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry.
Use special products to remove
the stubborn stains.
Incorrect temperature
was set.
Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
The appliance
does not dry or
does not dry cor-
rectly.
The water tap is not
turned on.
Turn the tap on.
The drain filter is clog-
ged.
Clean the drain filter.
There is too much laun-
dry in the drum.
Reduce the laundry load.
You have set a wrong
dryness level or drying
time.
Set additional drying time.
The laundry is full
of different colours
fluff.
The fabrics washed in
the cycle before released
fluff of different colours.
• The drying phase helps to re-
move some fluff.
• Clean the laundry with a fluff
remover.
If there is a big quantity
of fluff in the drum repeat
this procedure again and
again:
• Clean the empty drum, the
gasket and the door with a wet
cloth.
• Set a rinse cycle
• Put a wool or piled fabric cloth
in the drum.
• Set a drying cycle of 10 mi-
nutes
• Remove the old wool cloth.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
15. INSTALLATION
15.1 Fixing plate kit
(4055171146)
Available from your authorized dealer.
If you install the appliance on a plinth, se-
cure the appliance in the fixing plates.
Follow the instructions supplied with the
kit.
30
www.electrolux.com