User manual

reason, it is necessary to open it, set firstly
the machine to pause by pressing the button
7 .
• If the DOOR symbol disappears from the
display, the door can be opened.
• If the DOOR symbol stays on, and the door
remains locked, this means that the ma-
chine is already heating or that the water
level is too high. In this case the door can
not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
. After a few
minutes the door can be opened (pay at-
tention to the water level and tempera-
ture !) .
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 7 .
At the end of the programme
The machine stops automatically. The pilot
light of button 7 goes off and a blinking
appears on the display. The acoustic signal
sounds for a few minutes.
If you have chosen a programme or an option
that ends with water left in the tub, follow
the below instruction to empty the water
out:
•
turn the programme selector dial to
• select the draining or spinning programme
• reduce the spin speed if needed, by press-
ing the relevant button
•
press the button 7
• when the programme has finished the dis-
play shows a blinking
. On the display
the DOOR symbol disappears. The door
can now be opened.
Turn the programme selector dial to
to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew and
unpleasant smells.
Stand by : once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display
is reduced. By pressing any button the ap-
pliance will come out of the energy saving
status.
Use - Drying
Drying only
The recommended load size is 3.5 kg for
cottons and linen, and 2 kg for synthetic
items.
By pressing Drying Time button it is also
possible to dry up to 5 kg of cotton items
(see the «Drying Programme » table).
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin
speed allowed for the type of laundry in
order to obtain the best drying perform-
ances.
3. Select the drying programme for Cottons
or Synthetic in the Drying sector of the
programme selector dial. The DRYING
and the ANTI-CREASE symbols corre-
sponding to the phases making up the
programme appear on the display. At the
same time, the symbols corresponding to
the level degrees allowed by the set pro-
gramme/fabric and «AUTO» lights up.
4. – Select the automatic drying by
pressing the button 3 .
With this button you can select the de-
gree of dryness by an electronic drying.
The machine adapts automatically the
duration of the drying cycle to the se-
lected degree of dryness. If you press
this button, a black dash appears un-
der the selected symbol to indicate that
a degree has been set. The message
«AUTO» disappears. The display
shows the duration of the drying cycle.
The pilot light of button 7 starts blink-
ing. Press then button 7 to start the
programme. A black dash flashes un-
der the DRYING symbol.
electrolux 11